diff --git a/README.md b/README.md index 4328fb8..545a147 100644 --- a/README.md +++ b/README.md @@ -47,7 +47,7 @@ The Unifi UDM is built on a powerful quad core ARM64 CPU that can sustain up to chmod +x setup_wireguard.sh ./setup_wireguard.sh ``` - This will setup the symbolic links for the various binaries to the /usr/bin path as well as create a symlink for the /etc/wireguard folder and finally load the kernel module. You'll want to run **dmesg** to verify the kernel module was loaded. You should see something like the following: + This will set up the symbolic links for the various binaries to the /usr/bin path as well as create a symlink for the /etc/wireguard folder and finally load the kernel module. You'll want to run **dmesg** to verify the kernel module was loaded. You should see something like the following: ``` [13540.520120] wireguard: WireGuard 1.0.20210219 loaded. See www.wireguard.com for information. @@ -92,7 +92,7 @@ There's a sample WireGuard config file in /etc/wireguard you can use to create y cp /etc/wireguard/wg0.conf.sample /etc/wireguard/wg0.conf vi /etc/wireguard/wg0.conf ``` -There are various tutorials out there for setting up a client/server config for WireGuard (e.g. https://www.stavros.io/posts/how-to-configure-wireguard/ ). A typical config might be to allow remote access to your internal LAN over the WAN from a mobile phone or romaing laptop. For the purpose of this example, the UDM is the server and the phone/laptop the client. For this you would need to setup a config file on the UDM similar to the following: +There are various tutorials out there for setting up a client/server config for WireGuard (e.g. https://www.stavros.io/posts/how-to-configure-wireguard/ ). A typical config might be to allow remote access to your internal LAN over the WAN from a mobile phone or romaing laptop. For the purpose of this example, the UDM is the server and the phone/laptop the client. For this you would need to set up a config file on the UDM similar to the following: ``` [Interface]